Combination Centering and Riveting Punch-
Delivers quick automatic stroke, adjustable for light, medium, or heavy
impression. fitted with centering point. Also includes cup point and flat
point for riveting, burnishing, etc.
47.802
$35.40
Replacement Clutch for Combo Punch
47.803
$1.25
Replacement Spring for Combo Punch
47.804
$1.25
Replacement Shaft for Combo Punch
47.805
$2.55
Replacement Light Spring for Combo Punch
47.806
$.80
Replacement Centering Point for Combo
Punch
47.809
$4.90
Replacement Cup Point for Combo Punch
47.810
$3.15
Replacement Flat Point for Combo Punch
47.812
$3.15
Replacement Pointed Point for Combo Punch
47.811
$3.15
Replacement Knockout Point for Combo Punch
47.814
$3.15
Replacement Hammer for Combo Punch
47.818
$2.20
Automatic Center Punch-
Knurled screw cap can be adjusted for either light or heavy strokes. Pushing
down on body releases striking mechanism., The punch is pointed.
47.850
$51.75
Automatic Center Punch-
Slim design for better visibility. Pushing down on body releases striking
mechanism, which can be adjusted for light or heavy strokes. Removable
centering point can be interchanged with cup shaped riveting point. Picket
clip included. Includes centering point.
47.860
$19.20
Replacement Centering Point
47.866
$6.35
Center Punch- Made of
steel with knurled handle for firm gripping surface. Slim design. Can also
be used as scriber
47.900
$2.05
Set of 20 Pin Punches- Set
contains two each of 10 different size hardened steel punches. Flat tips
range from .020" to .050" in diameter and are easily ground to make other
sizes. Punches are 1-5/8" long, with a 3/32" shank. Used to drive out pins,
broken screws, riveting etc. Adjustable brass holder 3-1/4" long prevents
damage from hammer.
47.890
$44.60
Tap-It Punch
Punches brass or
copper up to 24 gauge. The Tap-It features a 1.5mm replaceable tip
(two extra tips are included) for just the right size holes.
Just place the
metal to be punched between the anvil part and the punch tip and give it a
light tap with a rawhide or plastic mallet. This method is much faster
than using drills or other conventional methods. Height is 4��.
Back
to 
Bench
Tools Gateway
